05-04-06
CA100
1
MODEL CA100
REMOTE CONTROL AUTO ALARM SYSTEM
INSTALLATION & OPERATION INSTRUCTIONS
WIRING DIAGRAM
Main 5 Pin White harness
6 Pin White Mini Connector
Black Antenna Wire
LED Indicator
Valet Switch
Blue Wire: (-) 200mA Unlock Pulse
Green Wire: (-) 200mA Lock Pulse
2 Pin
White
2 Pin
Blue
2 Pin
White
5 Pin
White
6 Pin
White
MAIN 5 PIN WIRE HARNESS:
5. Red Wire: +12V To Constant Battery Source
4. Brown Wire: Positive out
ut To Siren
3. Black Wire: Ground to Vehicle FRAME
2. White Wire: Parking Light Relay Output
1. Red / White Wire: Parking Light Relay Power Input
15A Fuse
6 PIN MINI CONNECTOR WIRE HARNESS:
6. Tan Wire: (-) 200mA Programmable Output
2. Blue Wire: Instant Trigger Ground Input
1. Violet Wire: Positive Door Pin Switch Input
4. Pink Wire: To I
nition Switched + 12V
5. Orange Wire: 200mA Grounded when armed
3. Green Wire: Negative Door Pin Switch Input
85
86
30
87a
Cut
To start solenoidFrom ignition switch
Red wire
White wire
Orange
wire
Channel 3 / 2 Step Door Unlock.
12V
12V
Yellow wire
A. PROGRAMMING TRANSMITTER:
Note:
This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
1. Turn the Ignition 'switch ‘OFF/ON’ 3 TIMES and stay in ON position. Within 15 seconds.
2. Push the Valet switch
3
times and holding in on
3rd
push until a long chirp is heard then release the valet
switch. You are now in the Transmitter programming mode.
3. Press and hold any button of the transmitter until the siren responds with a confirming chirp, indicating the
signal has been stored into memory.
4. If you have additional transmitters (up to 4) that need to be programmed, repeat step 3 for each transmitter.
