Filter
Top Products
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed,
it will automatically begin to record your steps, and
activity time. Repeatedly press the red MODE button to
cycle through the pedometer modes:
STEP → ACTIVITY TIMER → STEP
2-STEP DELAY FILTER
ACCUSPLIT has added a “2 step delay” filter to this
pedometer, to weed out false steps caused by tapping
the foot, sitting down, etc. The filter is set to “2 steps,”
meaning that the unit will wait to start counting steps
until more than two steps have been recorded. When
you are beginning a walk, the display will not show any
steps for a few seconds. After the unit has sensed three
steps, the display will register all of those steps at once,
and keep counting from that point.
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset:
press and hold the white RESET button for at least 2
seconds.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to
replace the battery. Your pedometer uses one Type L1142
(LR43) 1.5 volt silver oxide battery.
ATTACHING THE LEASH
Attach the pedometer to the
leash by looping the leash
through the pedometer leash
slot. Next, loop the leash
through the metal clip, then
clasp the waistband of your
clothing with the pedometer
belt clip.
Note: You can also use a safety
pin to fasten the leash to
your clothing, loop the leash
through your belt or belt loop,
or use a badge holder.
AE2720 Pedometer
INSTRUCTIONS
ACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • support@ACCUSPLIT.com
Congratulations on taking the first step to wellness
with your purchase of an ACCUSPLIT pedometer.
It’s easy to set up your new pedometer.
Just follow the steps below, and start walking!
Red:
MODE
9789
ACCUSPLIT EAGLE
�
STEP
▶
White:
RESET
970-076B
10/08
DISPLAY MODES
• STEP: STEP mode shows
your step count since last reset,
up to 1,000,000 steps.
• ◯: ACTIVITY TIMER
MODE shows total activity
time in minutes and seconds
since last reset. The timer runs
automatically whenever steps
are being recorded.
HOW TO OPEN YOUR PEDOMETER
See diagrams at right.
The cover must be closed for the
pedometer to work.
A
C
C
US
P
L
IT
A
LL
IANC
E
15
20
A
C
C
U
ST
E
P
1000
0.OR
G
RESET
�
AC
T
IVIT
Y
PEDOMETER
STEP
0
68440
WEARING YOUR PEDOMETER
Gently slide the pedometer onto
your belt or the top edge of your
pants or skirt. It should fit snugly
and level, above one knee. The
strong polycarbonate clip makes
it easy.
Note: The pedometer should be as vertical as possible.
Walkers with larger stomachs may find it helpful to wear
the pedometer farther back on the body, toward one hip.
The cover must be closed for the pedometer to work.
To avoid losing or dropping your pedometer, use the
included leash and clip to fasten the pedometer securely
to your clothing.
yes
no
First, loop the
pedometer leash slot
Next, loop the metal
clip, then clasp clothing
Or, loop a
badge holder,
then put into pocket
(Badge holder
not included)
Or, loop a belt or belt loop
To replace:
1. Insert a coin into the slot on the front of the
case, and twist counterclock-wise to loosen
the battery door.
2. Remove battery door and take out the old
battery. Replace it with a new battery. The
battery’s positive (+) terminal should be
FACE UP while you put it into the
pedometer.
3. Put the battery door back on and twist the
coin clockwise to tighten.
E Rig! W Mr!
Lv W!
ACCUSPLIT Lftl